Inside the tank are two bolts holding the tank on to the base. Unscrew these two bolts and carefully lift water quality the tank from the base. Remove tank to the trash.
Water leak detectors are alarms that alert you of leaks. They do not stop the water leak from happening. They also do not stop the leak after it happens or turn off the water line repair valve. You will still need to turn off the water valve yourself and contact a Utah plumber to come check out the plumbing issue.
One other common design that is considered "washerless" was made famous by Delta and copied by several other makers. It uses little "cup" seals that fit over springs recessed in the back of the valve body. The springs press these "seals" against the cartridge and regulate the flow through little tapered openings in the cartridge. If you have one of these and it's dripping, changing these springs and seals will usually correct it. Here's a tip. Once you have the cartridge out of the way, insert a phillips screwdriver into the seal and pop both the seal and spring out. Stick the new ones on the end of the screwdriver to help guide them into place. This is especially helpful if you don't have long slender fingers.
Working on the gas lines is also a complex job that only a licensed plumber can handle because it is very dangerous. Small leaks can't always be detected by odor alone, but a licensed professional has the proper equipment that's needed to ensure that you don't have any leaks in the line.
Keep an eye on any leaks in and around the house. Inspect taps, pipes and your roof regularly. Watch for leaks and if you find them, get it water line repair as soon as possible.
People who own rental properties are great ones to give you information. With all of the service people needed for maintenance on their units, they typically know who to call and what level of work they perform. Most property owners will be more than happy to give you the information you seek. In fact, they were probably in your shoes at one time.
Is your garbage disposal clogged, but it is turning ok? This may be due to a blockage in the pipe. If you look at the pipe work under your sink you will see that the disposal is connected to a pipe that should join to a U bend and providing it was installed correctly it should have a connector that can be undone. If you undo this connector the pipe will pull away and generally this is where most blockages occur. Remove the blockage and reconnect the pipe.